Announcement

Collapse
No announcement yet.

Weird planer problem

Collapse
This topic is closed.
X
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Weird planer problem

    Oops wrong forum

    Hey all

    I was milling up some stock today to face glue them to laminate some blanks... After I ran it through the jointer I put it through the planer but ended up with a really strange result...

    I'm getting some weird 'dip' in the board but across the board... And it's consistent... I couldn't get a good picture of it so I drew it...

    Anyone seen this before? Never had this problem...

    I check the table level... The knives are new and the planer sets them basically automatically... I have a rigid planer...

    Any help would be greatly appreciated...

    This is the wood in section and anywhere you take a straight edge across the top you see this dip... Click image for larger version  Name:	Snapchat-210568370.jpg Views:	1 Size:	605.0 KB ID:	1148983
    Last edited by AJ_Pauls; 11-13-2017, 10:40 PM. Reason: Wrong forum sorry
  • Thread Continues Below...

  • #2

    Re: Weird planer problem

    Thread continues here : https://forum.canadianwoodworking.co...planer-problem

    Comment

    Working...
    X