No announcement yet.

Leigh Super Jig 12" & VRS

  • Filter
  • Time
  • Show
Clear All
new posts

  • Leigh Super Jig 12" & VRS

    This 12" capacity dovetail jig from Leigh is versatile, easy to adjust, and quick to use.

    Like the D4R Pro jig, they produce through, half-blind, and sliding dovetail joints. In contrast with the D4R Pro, the design of the side stops also allows you to make box joints (with 5/16" and 5/8" fingers) and saves time when routing half-blind joints because the pin and tail boards are machined concurrently.

    The eccentric guide bushing simplifies fitting these joints by quickly and precisely changing the relationship between the cutter and finger assembly.

    Made largely from extruded aluminum, these jigs have sturdy cam locks and non-marring clamping surfaces.

    They cut 8° through dovetails in stock from 1/8" to 13/16" thick, as well as half-blind and sliding dovetails in material up to 1" thick. Spacing of pins and tails is completely variable; however, pin width depends on the diameter of the cutter. Built-in scales allow rapid and precise adjustment for material thickness and fine-tuning of through-dovetail fit.

    The finger assembly flips to change from through to half-blind mode, automatically orienting the scale correctly.

    New price is $482 gst in

    This jig was only used to make my kitchen drawers a few years ago so it has seen minimal use. Quite easy to set up and very accurate.

    Price for this one is $225 plus shipping.

    Click image for larger version

Name:	IMG_1247.JPG
Views:	287
Size:	2.54 MB
ID:	1256630
    Attached Files
  • Thread Continues Below...

  • #2

    Re: Leigh Super Jig 12" & VRS

    Pm sent


    • #3

      Re: Leigh Super Jig 12" & VRS

      Price reduced to $200 plus shipping


      • #4

        Re: Leigh Super Jig 12" & VRS

        friendly bump