Announcement

Collapse
No announcement yet.

WTB: Replacement fence (and track?) for Beaver/Rockwell 6201

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • WTB: Replacement fence (and track?) for Beaver/Rockwell 6201

    I just picked up a Beaver/Rockwell 6201 for $50, put a few weeks of elbow grease into it to repair the cast surface, replace damaged fasteners, bearings and pulley. Runs like a champ. The saw came with the original fence, which is just destroyed. It bows almost 1/2" in at the center, and even if I clamp a straight board to it I can't get it to lock into place parallel to the miter slots.

    I'm new to woodworking and I can't justify the cost of a new fence and rails (250 plus) for a saw I'm only into for 80 bucks so far. There doesn't seem to be any used fences/rails on the market around here (Southern BC). I would love a point in the right direction if possible.


  • Thread Continues Below...

  • #2

    Re: WTB: Replacement fence (and track?) for Beaver/Rockwell 6201

    you could consider building your own

    https://www.youtube.com/watch?v=JDVpFYDe6zM

    Comment

    Working...
    X