No announcement yet.

State Oscillating Spindle Sander - B-4

  • Filter
  • Time
  • Show
Clear All
new posts

  • State Oscillating Spindle Sander - B-4

    For Sale:

    State B-4 Oscillating Spindle Sander  

    Later model with Pozi-lok spindles. 3 throat plates, 4x 3/4" spindles for the rubber drums, 1x 3/4" abrasive sleeve spindle, 1x 3/4"-1/2" cut down spindle to take smaller rubber drums. 3x 3" tall rubber drums and a quantity of 3" dia x 3" tall abrasive sleeves.

    1/2hp, 208-220/440V, 3-Phase motor (original Doerr, integral to the unit)

    Intention was to purchase a 1-phase 220V to 3-phase 220V VFD drive, and I did acquire a small electrical enclosure for the job.

    AS-IS. The original owner told me it works fine but I have not put power to it. The oscillation motion works smoothly when it's spun by hand. The spindle draw-bars have been modified by welding a different thread to the bottom, implying that the female thread in the collet is not good. Again, I have not disassembled the unit to get a better idea of what's going on.

    I bought this as a project that never quite got to the top of the list. It's time to move it on to someone who will enjoy it.

    $250 OBO
    Located in Kingston
  • Thread Continues Below...