Announcement

Collapse
No announcement yet.

Anyone familiar with Grizzly Overhand Router G8030?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • nnieman
    replied
    Thanks Rob

    Anything I should look for when I check it out?
    other than the obvious signs of damage/ bearing noise.

    Nathan

    Leave a comment:


  • iamtooler
    replied
    That must be a flat belt drive using a ''c'' frame motor. It is not much more compact than my small Wadkin direct drive. I am not sure why they include a tilting table and hydraulic feed? I can supply a transformer and drive for 225$ if you need to keep the motor.

    Oops, just realized at 3hp my transformers are too small though I am sure they would handle the load. I have been using them on drill presses typically only 1.5 or 2 hp. It is difficult to consume much power on a drill.
    Last edited by iamtooler; 02-17-2020, 10:07 AM.

    Leave a comment:


  • nnieman
    started a topic Anyone familiar with Grizzly Overhand Router G8030?

    Anyone familiar with Grizzly Overhand Router G8030?

    I have a lead on a Grizzly Pin Router

    https://www.amazon.com/Grizzly-G8030.../dp/B0000DD6WM

    I am not familiar with them at all.
    The size is nice and compact.
    I am wanting a smaller one for guitar bodies, I dont need something huge and industrial.

    Secondly, how easy is it to change out the motor?
    The one I am looking at has a 575 volt.

    It looks like a belt drive and I have a 3 hp single phase here.

    Thanks

    Nathan
Working...
X