Anyone familiar with Grizzly Overhand Router G8030?

[nnieman [OP]]

I have a lead on a Grizzly Pin Router

https://www.amazon.com/Grizzly-G8030.../dp/B0000DD6WM

I am not familiar with them at all.
The size is nice and compact.
I am wanting a smaller one for guitar bodies, I dont need something huge and industrial.

Secondly, how easy is it to change out the motor?
The one I am looking at has a 575 volt.

It looks like a belt drive and I have a 3 hp single phase here.

Thanks

Nathan

[iamtooler]

That must be a flat belt drive using a ''c'' frame motor. It is not much more compact than my small Wadkin direct drive. I am not sure why they include a tilting table and hydraulic feed? I can supply a transformer and drive for 225$ if you need to keep the motor.

Oops, just realized at 3hp my transformers are too small though I am sure they would handle the load. I have been using them on drill presses typically only 1.5 or 2 hp. It is difficult to consume much power on a drill.

[nnieman [OP]]

Thanks Rob

Anything I should look for when I check it out?
other than the obvious signs of damage/ bearing noise.

Nathan