Announcement

Collapse
No announcement yet.

Wiring table saw switch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16

    Re: Wiring table saw switch

    Stevem I meant to say the welder requires 120 20 amp and I can't put both a dedicated 120 20 amp breaker and a 220 20 amp dual pole braker because my panel doesn't have the room. Thus the one 120 20 amp outlets for both saw and welder to be used at different times because the saw is dual voltage.

    Comment

    • Thread Continues Below...

    • #17

      Re: Wiring table saw switch

      I'm not sure what the real rule is on overload protection but I've been running a TS 2HP motor for years without any AFAIK. The TS is an intermittent, attended (you are operating it manually) load not a motor up in a remote location that runs automatically.
      So what this means is that if it is on, I'm present. If the motor is in an overloaded condition while cutting then I should be well aware of that situation and shut ti down before lthe smoke belches forth. If the motor develops a serious short circuit the circuit breaker will trip.
      billh
      iamtooler likes this.

      Comment


      • #18

        Re: Wiring table saw switch

        Virtually all single phase induction motors have integral OL protection, sometimes there's a reset button on the motor, sometimes it's auto resetting with no button.

        Comment


        • #19

          Re: Wiring table saw switch

          motor may say overload protection or none

          reset button on motor is protection

          Comment


          • #20

            Re: Wiring table saw switch

            the bottom of your motor id plate says no protection.
            you need a switch with protection

            Comment


            • #21

              Re: Wiring table saw switch

              did your saw not have a magnetic starter orginally

              Comment

              • Thread Continues Below...

              • #22

                Re: Wiring table saw switch

                Ytsawman the saw originally came with a 3 phase motor here is the original switch maybe can be refurbished for single phase 120 I don't know
                Attached Files

                Comment


                • #23

                  Re: Wiring table saw switch

                  don't think that switch can do 110 volts, looks like it could be used for 220v but you may have to change the overload aND POSSIBLY COIL. SOMETIMES THOSE MIGHT BE MORE THAN A NEW SWITCH

                  Comment


                  • #24

                    Re: Wiring table saw switch

                    That switch has a 575 volt coil. You can't use in your home.

                    Comment


                    • #25

                      Re: Wiring table saw switch

                      CHECK THIS ONE OUT, DOES YOUR SWITCH HAVE THE BUTTONS IN COVER WITH WIRES TO THE OTHER STUFF.SWAP OUT WITH THIS



                      https://www.ebay.com/itm/Schneider-M...AAAOSw~ERdzXCc

                      Comment


                      • #26

                        Re: Wiring table saw switch

                        Here is the cover don't know if it will work.what do you think ytsawman
                        Attached Files

                        Comment

                        • Thread Continues Below...

                        • #27

                          Re: Wiring table saw switch

                          Not worth using that switch at all

                          Comment

                          Working...
                          X