Tweet
Looking for someone in Toronto who has a metal lathe and could help out with truing up the flanges on a small Baldor grinder. Trying to eliminate a small bit of side to side wobble on one side.
- First visit? Check out our HELP page for info on how to use this Forum.
Visitors are welcome to read posts, but must REGISTER to make posts.
For a step-by-step guide on how to register, CLICK HERE
To view posts, choose a subforum from the selection below.
Powered by vBulletin®
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.
All times are GMT-5. This page was generated at 03:54 AM.