Results 1 to 1 of 1

Thread: PM Vise Restoration

  1. #1

    Default PM Vise Restoration

    Hello all, recently picked up a Yost pattern makers vise. In good working shape but could use a restoration. I am unfamiliar with doing this kind of work and am interested in any suggestions. I am considering taking it somewhere but do not want to spend to to much on it at this point seeing as it functions just fine. It is mostly just a couple little spots of surface rust, however the hinge plate is not original and needs to be ground flush. Thanks in advance for the help folks.

    This link goes to the pictures....couldn't figure out posting the pictures in here, and imgur is easy, four pictures total.

  2. Thread Continues Below...

Similar Threads

  1. Homemade Bench, Twin screw vise and holdowns!
    By Erron in Arnprior in forum Woodworking
    Replies: 32
    Last Post: 02-21-2011, 02:34 PM
  2. Record Vise - Restoration/Questions
    By DiggingOut in forum Hand Tools
    Replies: 13
    Last Post: 07-09-2010, 10:16 AM
  3. Question about tail vises
    By Ed in Stittsville in forum Hand Tools
    Replies: 3
    Last Post: 01-14-2009, 07:32 PM
  4. Lee Valley Quick release front vise problem
    By Cooper in forum Shop Related Discussions
    Replies: 4
    Last Post: 09-24-2007, 06:53 AM
  5. Wood Working Vise
    By Stephan in St George in forum Shop Related Discussions
    Replies: 7
    Last Post: 08-02-2006, 11:14 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts