Re: Using a router table and roundover bit - some basic questions
Thanks for the link Michael, now I get it!
Thread Continues Below...
By Bri in Mtl in forum Power Tools
Last Post: 12-20-2011, 10:36 AM
By TheKingInYellow in forum The Swap Meet
Last Post: 01-30-2011, 11:03 AM
By John in London in forum Power Tools
Last Post: 12-07-2010, 07:48 PM
By marvintpa in forum Woodworking
Last Post: 08-10-2010, 11:35 PM
By Edward T in forum Woodworking
Last Post: 12-20-2009, 09:17 PM